Home / Goniometer Stages / CYDAV80-50-42
Series photograph This picture shows a representative unit from the series, not this exact model — the rotation centre height differs between them. Work from the drawing for the mounting pattern and every dimension.
Goniometer stage
CYDAV80-50-42
Arc swing about a rotation centre above the table, for tilt alignment without translating the part. Table 80×80 mm.
Arc± 7.5°
Centre height50±0.2mm
Repeatability± 0.002°
Load7kg
Use the source drawing below for initial integration. Before release, confirm its current revision, connector information where applicable, and an available CAD format for this exact model.
Source drawing
Download drawingDimensioned drawing
Specifications
and how each figure is established| Parameter | Value | Unit | Basis |
|---|---|---|---|
| Identity | |||
| Series | Goniometer Stages | — | Catalogue |
| Motor / actuation | Not stated | — | Not confirmed |
| Geometry | |||
| Table size | 80×80 | mm | Catalogue |
| Stage height | 25±0.2 | mm | Catalogue |
| Rotation centre height | 50±0.2 | mm | Catalogue |
| Performance | |||
| Total arc | 15 (± 7.5) | ° | Derived |
| Maximum speed | 10.5 | °/s | Catalogue |
| Repeatability | ± 0.002 | ° | Catalogue |
| Backlash | 0.003 | ° | Catalogue |
| Payload | 7 | kg | Catalogue |
| Asked for on every export inquiry | |||
| Bidirectional repeatability | — | µm | Not confirmed |
| Measurement standard | — | — | Not confirmed |
| Test temperature | — | °C | Not confirmed |
| Load condition during test | — | — | Not confirmed |
| Vertical and moment load limit | — | N·m | Not confirmed |
| Motor holding torque | — | N·m | Not confirmed |
Catalogue — transcribed from the published catalogueDerived — computed from the catalogue, notation normalisedNot confirmed — absent, ambiguous, or not reliably mapped from the source
Supply scope to confirm
quotation checklist| Item | Catalogue status | Detail |
|---|---|---|
| Stage assembly | Catalogue listed | Crossed roller |
| Motor | Not stated | The source catalogue does not identify a motor for this model. |
| Drive / amplifier | Not stated | Confirm the required drive and whether it is included in the quotation. |
| Controller | Not stated | Confirm controller compatibility and supply responsibility in the quotation. |
| Cable set | Not stated | Confirm connector type, pinout, cable length and whether a cable is included. |
| Dimensioned drawing | Published | The printed catalogue drawing is published on this page. Confirm the current revision before release. |
| CAD | Not stated | Request the available CAD format before release. |
| Mounting hardware | Not stated | Confirm fasteners, adapter plates and mounting interfaces for the application. |
The catalogue does not define a complete shipping bundle. Record each item explicitly in the quotation so the stage, electronics, cabling and mounting interfaces are unambiguous.