Home / Rotary Stages / CYDRA100-360-42
Illustrative Studio image derived from the supplied catalogue photograph. For the mounting pattern and every dimension, work from the drawing, not this picture.
Rotary stage
CYDRA100-360-42
Limited-arc ball-screw drive and continuous 360° worm gear, to ±0.002° repeatability. Table φ100 mm.
Range360°
Accuracy0.05°
Repeatability± 0.005°
Centre load15kg
Use the source drawing below for initial integration. Before release, confirm its current revision, connector information where applicable, and an available CAD format for this exact model.
Source drawing
Download drawingDimensioned drawing
Specifications
and how each figure is established| Parameter | Value | Unit | Basis |
|---|---|---|---|
| Identity | |||
| Series | Rotary Stages | — | Catalogue |
| Motor | 42 stepper | — | Catalogue |
| Drive mechanism | Worm gear 180:1 | — | Catalogue |
| Limit and origin sensor | Built-in origin | — | Catalogue |
| Mass | 1.7 | kg | Catalogue |
| Geometry | |||
| Table size | φ100 | mm | Catalogue |
| Performance | |||
| Range | 360 continuous | ° | Catalogue |
| Maximum speed | 20 | °/s | Catalogue |
| Positioning accuracy | 0.05 | ° | Catalogue |
| Repeatability | ± 0.005 | ° | Catalogue |
| Parallelism | 0.08 | mm | Catalogue |
| Backlash | ± 0.01 | ° | Catalogue |
| Motion concentricity | ± 0.03 | mm | Catalogue |
| Centre payload | 15 | kg | Catalogue |
| Asked for on every export inquiry | |||
| Bidirectional repeatability | — | µm | Not confirmed |
| Measurement standard | — | — | Not confirmed |
| Test temperature | — | °C | Not confirmed |
| Load condition during test | — | — | Not confirmed |
| Vertical and moment load limit | — | N·m | Not confirmed |
| Motor holding torque | — | N·m | Not confirmed |
Catalogue — transcribed from the published catalogueDerived — computed from the catalogue, notation normalisedNot confirmed — absent, ambiguous, or not reliably mapped from the source
Supply scope to confirm
quotation checklist| Item | Catalogue status | Detail |
|---|---|---|
| Stage assembly | Catalogue listed | Worm gear · Worm gear 180:1 · Sensor entry: Built-in origin |
| Motor | Catalogue listed | 42 stepper |
| Drive / amplifier | Not stated | Confirm the required drive and whether it is included in the quotation. |
| Controller | Not stated | Confirm controller compatibility and supply responsibility in the quotation. |
| Cable set | Not stated | Confirm connector type, pinout, cable length and whether a cable is included. |
| Dimensioned drawing | Published | The printed catalogue drawing is published on this page. Confirm the current revision before release. |
| CAD | Not stated | Request the available CAD format before release. |
| Mounting hardware | Not stated | Confirm fasteners, adapter plates and mounting interfaces for the application. |
The catalogue does not define a complete shipping bundle. Record each item explicitly in the quotation so the stage, electronics, cabling and mounting interfaces are unambiguous.