Home / Rotary Stages / CYDRA80-20-28
Series photograph This picture shows a representative unit from the series, not this exact model — the table diameter and travel differs between them. Work from the drawing for the mounting pattern and every dimension.
Rotary stage
CYDRA80-20-28
Limited-arc ball-screw drive and continuous 360° worm gear, to ±0.002° repeatability. Table φ80 mm.
Range± 10°
Accuracy0.02°
Repeatability± 0.003°
Centre load7kg
Use the source drawing below for initial integration. Before release, confirm its current revision, connector information where applicable, and an available CAD format for this exact model.
Source drawing
Download drawingDimensioned drawing
Specifications
and how each figure is established| Parameter | Value | Unit | Basis |
|---|---|---|---|
| Identity | |||
| Series | Rotary Stages | — | Catalogue |
| Motor | 28 stepper | — | Catalogue |
| Drive mechanism | Ball screw φ6 lead 1 | — | Catalogue |
| Limit and origin sensor | External | — | Catalogue |
| Mass | 0.9 | kg | Catalogue |
| Geometry | |||
| Table size | φ80 | mm | Catalogue |
| Performance | |||
| Range | 20 (± 10) | ° | Derived |
| Maximum speed | 16 | °/s | Catalogue |
| Positioning accuracy | 0.02 | ° | Catalogue |
| Repeatability | ± 0.003 | ° | Catalogue |
| Parallelism | 0.04 | mm | Catalogue |
| Backlash | ± 0.01 | ° | Catalogue |
| Motion concentricity | ± 0.03 | mm | Catalogue |
| Centre payload | 7 | kg | Catalogue |
| Asked for on every export inquiry | |||
| Bidirectional repeatability | — | µm | Not confirmed |
| Measurement standard | — | — | Not confirmed |
| Test temperature | — | °C | Not confirmed |
| Load condition during test | — | — | Not confirmed |
| Vertical and moment load limit | — | N·m | Not confirmed |
| Motor holding torque | — | N·m | Not confirmed |
Catalogue — transcribed from the published catalogueDerived — computed from the catalogue, notation normalisedNot confirmed — absent, ambiguous, or not reliably mapped from the source
Supply scope to confirm
quotation checklist| Item | Catalogue status | Detail |
|---|---|---|
| Stage assembly | Catalogue listed | Bearing · Ball screw φ6 lead 1 · Sensor entry: External |
| Motor | Catalogue listed | 28 stepper |
| Drive / amplifier | Not stated | Confirm the required drive and whether it is included in the quotation. |
| Controller | Not stated | Confirm controller compatibility and supply responsibility in the quotation. |
| Cable set | Not stated | Confirm connector type, pinout, cable length and whether a cable is included. |
| Dimensioned drawing | Published | The printed catalogue drawing is published on this page. Confirm the current revision before release. |
| CAD | Not stated | Request the available CAD format before release. |
| Mounting hardware | Not stated | Confirm fasteners, adapter plates and mounting interfaces for the application. |
The catalogue does not define a complete shipping bundle. Record each item explicitly in the quotation so the stage, electronics, cabling and mounting interfaces are unambiguous.