Home / Motorized Linear Stages / CYGXN60-0601-20-28
Series photograph This picture shows a representative unit from the series, not this exact model — the travel differs between them. Work from the drawing for the mounting pattern and every dimension.
Linear stage
CYGXN60-0601-20-28
Ball-screw driven single-axis translation on crossed-roller or linear-ball guideways. Table 60×60 mm.
Travel20mm
Table60×60mm
Repeatability± 0.3µm
Accuracy5µm
Load5kg
Use the source drawing below for initial integration. Before release, confirm its current revision, connector information where applicable, and an available CAD format for this exact model.
Source drawing
Download drawingDimensioned drawing
Specifications
and how each figure is established| Parameter | Value | Unit | Basis |
|---|---|---|---|
| Identity | |||
| Series | Motorized Linear Stages | — | Catalogue |
| Motor | 28 stepper | — | Catalogue |
| Limit and origin sensor | Built-in | — | Catalogue |
| Mass | 0.54 | kg | Catalogue |
| Geometry and travel | |||
| Table size | 60×60 | mm | Catalogue |
| Total travel | 20 (catalogue prints ±10) | mm | Derived |
| Ball screw | φ8 lead 1 | — | Catalogue |
| Guideway | Crossed roller | — | Catalogue |
| Body material | Aluminium | — | Catalogue |
| Surface treatment | Black anodised | — | Catalogue |
| Performance | |||
| Unidirectional positioning accuracy | 5 | µm | Catalogue |
| Repeatability | ± 0.3 | µm | Catalogue |
| Maximum speed | 10 | mm/s | Catalogue |
| Parallelism | 40 | µm | Catalogue |
| Motion parallelism | 20 | µm | Catalogue |
| Straightness | 10 | µm | Catalogue |
| Payload | 5 | kg | Catalogue |
| Asked for on every export inquiry | |||
| Bidirectional repeatability | — | µm | Not confirmed |
| Measurement standard | — | — | Not confirmed |
| Test temperature | — | °C | Not confirmed |
| Load condition during test | — | — | Not confirmed |
| Vertical and moment load limit | — | N·m | Not confirmed |
| Motor holding torque | — | N·m | Not confirmed |
Catalogue — transcribed from the published catalogueDerived — computed from the catalogue, notation normalisedNot confirmed — absent, ambiguous, or not reliably mapped from the source
Supply scope to confirm
quotation checklist| Item | Catalogue status | Detail |
|---|---|---|
| Stage assembly | Catalogue listed | Crossed roller · φ8 lead 1 · Sensor entry: Built-in |
| Motor | Catalogue listed | 28 stepper |
| Drive / amplifier | Not stated | Confirm the required drive and whether it is included in the quotation. |
| Controller | Not stated | Confirm controller compatibility and supply responsibility in the quotation. |
| Cable set | Not stated | Confirm connector type, pinout, cable length and whether a cable is included. |
| Dimensioned drawing | Published | The printed catalogue drawing is published on this page. Confirm the current revision before release. |
| CAD | Not stated | Request the available CAD format before release. |
| Mounting hardware | Not stated | Confirm fasteners, adapter plates and mounting interfaces for the application. |
The catalogue does not define a complete shipping bundle. Record each item explicitly in the quotation so the stage, electronics, cabling and mounting interfaces are unambiguous.